@AB-Buff

Lincoln 1932-39 V12 replicated Auto-Lite IGM-16 rotors

AB-Buff · 2018-05-31T15:47:15.000Z

After two years for searching for a NOS Auto-Lite IGM-16 rotor and not finding one I decided to do a limited run of IGM-16 rotors. These rotors are made from a nearly unbreakable polyurethane (you will not break one with normal usage). They come with a new conductive graphite button .050” longer…

May 31, 2018790 views

Reply to AB-Buff…

Replies (4)

· May 31, 2018

Nice work,

looks like the same as in my 1930 studebaker President.

would it fit a 668c delco dist.??

ken

· May 31, 2018

Hi Ken

I have no idea, the shaft it fits is .625" if that helps. I will post the diameter of the contacts a little later today, just now running off for a few hours.

Lynn

· May 31, 2018

It would be great to have some of the critical dimensions, it looks like it might replace NE 5033469 used in 33/34 Packard Eight and Super Eight, and in short supply. No offset between the two ends, exactly 180 degrees apart?

· Jun 1, 2018

I took a few measurements this morning, these are all close and may not be exact but you should be able to see if this will work for you. If anyone has a rotor that is in short supply I would consider doing a run of them, maybe 8-10 minimum. It's a lot of work to get them to the finish line. All of the brass has to be milled to size, width and length, radius cut, spot faced for the tube, soldered etc. Then making the mold and the rest of the process.